` How to set VISCA/Pelco-D/Pelco-P protocol at PTZ controller and PTZ camera - Zowietek Electronics, Ltd.
How can we help?

Welcome to Zowietek Support!

Popular searches: PTZ Camera, LiveV400, GeneralFAQ

< All Topics
Print

How to set VISCA/Pelco-D/Pelco-P protocol at PTZ controller and PTZ camera

NOTE: The PTZ camera remote control settings parameters must be consistent with the Camera Controller settings, otherwise the Camera Controller cannot control the PTZ camera. The addresses under different protocols can be the same or different, but under the VISCA protocol, PTZ camera address range: 1 to 7, under the Pelco-P/Pelco-D protocol, PTZ camera address range: 0 to 255.

In normal working mode, press [MENU] key to display the menu, using scroll arrow to point at or highlight the selected items.

Using scroll arrow to “SETUP”, enter into “system setting”.

VISCA Address: 1~7

PELCO-P Address: 0~255

PELCO-D Address: 0~255

Baudrate: 9600

PTZ Controller (90950-210)  setup

 
PTZ Setup E.g.  With address code 28, steps to change to VISCA/PELCO-D/PELCO-P protocol and baud rate to 9600 are as follows: Press [SETUP] button for 3 seconds under normal working mode, it displays as follows:

Enter password:

(default is 8888)

Press [ENTER]

Press [2] [8]

Press[ENTER]

Move joystick downward to choose the right protocol.

Move joystick rightward to choose the right BR (baudrate).

Then press [ENTER] , there will be a 1sec beep sound when setting done.

Press [ESC] 3 times to back to normal working mode.

Note: Steps to set all devices to be with same protocol and baud rate are as follows:

Enter the setup page.
Choose the corresponding protocol and baud rate. Then all devices within 0-255 addresses are set with the same protocol and BR (baudrate).

Universal PTZ Controller (90950-220) setup

VISCA Mode Setting

Control settings (set the baud rate for a certain address code):

Move the joystick up, down, left and right to switch addresses (1-7) → ENTER → Move the joystick left and right to switch baud rate → ENTER.

EX: Select the address: 1 → ENTER → Select the baud rate: 9600 → ENTER.

When the controller switch to address 1, the control baud rate is 9600.

PELCO Mode Setting

Control settings (set the baud rate for a certain address code):

Move the joystick up, down, left and right to switch addresses (1-255) → ENTER → Move the joystick left and right to choose protocols → ENTER → Move the joystick left and right to switch baud rate → ENTER.

EX: Select the address: 1 → ENTER → Select the protocol: Pelco-D → ENTER → Select the baud rate: 9600 → ENTER.

When the controller switch to address 1, the control baud rate is 9600, protocol is Pelco-D.

 

Previous How to control your PTZ cameras by vMix
Table of Contents
Copyright © 2016 Zowietek Electronics, Ltd. All rights reserved.  Privacy Policy